Hi, I have two sites, 1 with Cisco CME (2901 voice) and the other with Cisco BE 3000. Point-to-point video call are working properly in both sites. Sites are connected through SIP trunk. In site 1 (CME), CP8945 use SCCP firmware (9.4), in Site 2 (BE 3000) CP 8945 use SIP firmware (9.X). SIP trunk config on CME: dial-peer voice 12 voip description trunk dla destination-pattern 05.. video codec h264 session protocol sipv2 session target ipv4:192.168.0.26 incoming called-number 05.. dtmf-relay sip-notify no vad Telephony Service config on CME: telephony-service video maximum bit-rate 1024 service phone videoCapability 1 Ephone config: ephone 29 video mac-address 64A0.E7F6.1005 username "Herve NGONDIEP" password 123 type 8945 button 1:29 SIP global config: voice service voip allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none h323 call start slow sip bind control source-interface GigabitEthernet0/0.10 bind media source-interface GigabitEthernet0/0.10 asymmetric payload full voice class codec 1 codec preference 1 g729r8 codec preference 2 g729br8 codec preference 3 g728 codec preference 4 g711alaw codec preference 5 g711ulaw In site 1 (BE 3000), i've enable video under SITES>QUALITY and set Bandwith to T1 ------- Audio call between all other phones from site 1 to site 2 are ok. Audio call between Normal phones (all with SIP) in site 1 and video phone in site 2 (8945 with SCCP) ie running one way (the remote peer don't hear but the site 1 peer is hearing well). Please, do you find any mistake in my CME config? Can you help me overcome this issue? Thanks!
... View more
Hi, i have 2 sites, h323 interconnected. one with BE 3000 and an other with CCME 2901V/k9 Is point to point video call possible between those sites? Do i need to purchase a feature licence to make CME able to handle video call (assumed that CME already has UC licence)?
... View more