Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am trying to make a site2site connection on the same firewall between 2 contexts.
One context is not sending, so no tx.....
IKEv2 SAs:
Session-id:114325, Status:UP-ACTIVE, IKE count:1, CHILD count:1
Tunnel-id Local ...
Hello,
i need to create a new vlan with internet access. In the cisco firewall on the particular context I created a new interface. Internet works, all ok.
The problem is that the subnet is the same as the subnet on the customer side which is con...
Hello, we have a site2site with an external company, site2site is not working...I do not know what to do. I *think* the other side is using juniper. Tunnel is UP, but I have no Tx packets for tunnel 0.0.0.0/0 to 10.0.0./16I also have 2 ACLs in the cr...
Hello, I have an issue all of a sudden with a cisco 2960 We have a MPLS connection between two sites which worked until 2-3 hours ago.I did some work on the remote side today, but as I tested everything looked OK, only after I logged in aprx 1 hour l...
Hello, I have a Site2Site connection which is working fine. I added another host from another subnet to the config but there is only 1 way communication. inside interface 10.10.0.0vpn peer 10.0.11.0 Host added to config from 10.0.0.x, no TX. There ...
yes, asa fw. Right now I am looking for the connection to work without disrupting the existing vpn.
10.10.0.0 must exist in our network, it must not speak to the customer side, so for now I do nt need the overlapping vpn.
But since we already have a...
