Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am in the middle of my N1k upgrade and seem to be stuck. I have upgraded both VSM's with no issue. After notifying the vCenter server and accepting the upgrade, I tried the "vmware vem upgrade proceed" command and keep hitting the attached error....
Go into the BIOS of the server and disable quiet boot. Once this is done reboot the server and enter the LSI config during the boot process. I think it is a ctrl-S to get into the LSI config. Once you are in the LSI config you can set the RAID lev...
Yes the uplink ports need to be connected in order for your vNIC's to work. Also I noticed that your vNIC is not set as a trunk and is only accessing the MGMT vlan. If you want your ESXi host to access multiple VLAN's you will need to set this as ...
You need to connect the uplink ports on your 6100's. The management ports are only for KVM or IPMI access to the blades. They will not supply connectivity for the vNIC's. Your ESXi install is attempting to connect to the network via the vNIC's. A...
The L1/L2 ports are for clustering two 6100's together. Use a regular Cat5 cable to connect the L1 on switch1 to the L1 port on switch2 and do the same with the L2 ports. Then console to the first switch and run through the setup dialogue. If the ...
