i created L3VPN senario to test MPLS VRF traceroute functionalityCE-1 (R1) 1.1.1.1 CE-2 (R6) 6.6.6.6when i did traceroute from CE-1 to CE-2 , below output is getting , but my question is when R3(P) router receive the traceroute with ttl 1 s...
Hi Team,
i have one query if we change the IBGP over loopback GR (switchover timers to warm reboot timers ) so in this case do we need to do
clear ip bgp
(hard reset) for negotiate the timers or will it automatically negotiate
...
Hi, i have recovered my cisco ASR903 from rommon mode and i am facing one issue .bin file not showing in #sh bootflash: and when i triggered cold reboot is not booting from new image it showing no bootable disk found it and rommon mode is openin...
hi , i have given 10 network IP in rommon mode and hit set but after that it showing below 30 subnet ommon 2 > IP_ADDRESS=10.10.10.2rommon 3 > DEFAULT_GATEWAY=10.10.10.1rommon 4 > IP_SUBNET_MASK=255.255.255.0rommon 5 > setPS1=rommon ! >LICENSE_B...
Hi Harold Ritter still have doubtwhen a customer trigger a traceroute from CE-1 devices then PE-1 will add two stack one is MPLS transport label to reach other PE and other one is VPN label used to reach CE-2 but when a P router recieves the tracerou...
Hi M02@rt37
i think
clear ip bgp * soft
command can't hep to re-negotiate the timers (it is generally for prefixes and policies ) , we need to perform hard reset then only BGP open message will send
what is the command to delete bin file from rommon mode on cisco ASR903i have tried to boot image from >dir bootflash: but getting error unable to read block 1895604205boot : unable to load "image"