Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi My plans are to run Routed acces in my LAN, However that requires lot of addresses so thought of using 31-bit prefixes. Now I am facing a problem. After using 31-bit prefixes in my point to point interfaces, those IP addresses dont ping at all fro...
Hi GuysI am having few BR350 radios with me, all are running VXworks version 12.05.I am trying to configure these boxes to use Tacacs+ for management traffic.Does anybody have an Idea how to do this in these boxes?Thanks in advanceRegardsSachendra
Hi allI am facing a strange problem today. I have a 1242 root and a 1242 nonroot associated to each other via the "a" radio. When I check the association table of the root, I can see that the Root is associated to a different IP address than the Nonr...
I have a cisco 1242 with IOS version 12.3.11(JA1)and two Non-root bridges. One of the Non root bridges is a Cisco 1242 with IOS version 12.3.11(JA1)and another Non-root bridge is a Wireless bridge BR-350 with VX-works version 12.05.In the above scena...
Hi I have a set up with 1 root bridge, many Nonroot bridges and many workgroup bridges.I have 2 VLANs configured in the ROOT and NONROOT bridges one of 146.35.x.x network (native VLAN) and 172.16.x.x.Now the nonroot bridges are BR350s, WGB are WGB350...
Hi allI have worked on VRF quite a bit now in many of the boxes like Catalyst 3800, Catalyst 6500 and Cisco 7206. As per my experience it works well but you need a proper IOS code running in these boxes, so you might need to check the cisco featurese...
Thanks for your replyBut I have read this document multiple times. Probably you have not read my question properly...I wanna know, if Catalyst 3750 switches support 31-bit prefix and if they do what IOS code needs to be run on them?Thanks
HiThanks for this document. I had got my case resolved last Friday, However this document is real good and is the right way to configure the ACS server for this requirement.SincerelySachendra
