Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We got a warning "the assigned pool does not have any free addresses to allocate" on my intersight IMM on my service profile on UCSX, but we doesn't see any error on pools or policy.
Hi All,
I want to ask regarding UCSX IMM M7 Server after performing a firmware upgrade while the server is powered off, after the update nears completion and ESXi boots up then it goes to shut down . ESXi 8.0U3 is installed on the system. We observed...
Hi All,
I want to know about can UCSX be managed without intersight, just like B series be managed by UCSM on FI?
And if UCSX has already been managed by Intersight, can it be converted to manage by UCSM?
Hi All,
I wonder , if there 4 fc uplinks on each FI A and FI B (no port-channel), there are 2 vhba on each blases and goes to FI-A and FI-B, no config pin group.
If there is fc uplink down, the vhba pin to the down port will be repinned to other av...
Hi All,
I have checked UCSX install GPU Card, I knowvthere are two types of installations GPU One type of architecture is direct installation Nvidia L4 GPU on X210C , but it needs to be install X10c Front Mezzanine GPU Module , another type is PCIE N...
Hi @Brian Morrissey ,
All pools are is it all used, only IP pools are reserved.
There was a profile that had been duplicated in the Mac pool configuration earlier, but I later reverted it.
Furthermore, all servers have been successfully installed w...
@Riaan van Niekerk ,
Thank you for your reply.
1. I comform again, so UCSX also can be managed by ucsm, Not necessarily be managed by intersight!?
2. If we want to covert to UMM, we have to reset FI and choose UMM, and all profiles have to rebuild,
b...
@Steven Tardy
Our two be6k servers on the same network, we can ping two servers,
the two servers on the other site no manage by intersight,
I alse use ucs_ipmi_tool on esxi, but it show "Get Device ID command failed".
and we'll try to shutdown the...
