Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyoneI must say I really hates the way Cisco made the devicepacks for LMS. Half of it is missing readme files and it's difficult to find a simple way to realise which packs you actually need... This could have been made so much easier...I also...
Hello everyoneI found a very strange thing in the command action lable string rangeI am trying to pick out a part of the string based on two variables but only get "invalid input detected"action 5.0 string range $str $str_first $str_lastif i go by st...
Hi again everyoneIs looking into a bigger deployment where we want to change certain parameters to interfaces belonging to certain vlans.Something like thisfor each interfaceif vlan=10clicommand1clicommand2end ifnext intIs this possible using velocit...
Hi everyoneI am trying to list all 802.1x unauthorized clients/ports in a larger network consisting of catalyst 3k:s Is there any good way to get a list of this in Prime Infrastructure or LMS and what is the best way of doing this ? Anyone know any g...
Hi Jamie
Don't know if this works in PI 2.2 and haven't tried it myself.In PI 3.0 you can change the severity of alarms under Administration->Settings->System settings->Alarm and Events->Alarm and events There should be a simular way in PI 2.2
I think you are attacking this from the wrong direction. That ports goes down could sometimes be very importent (trunk-links, etherchannels etc) However as you already notice you only wants the critical ones... I would suggest you configure your clie...
Hi michaelThere are some documentation on the Compliance feature in the Prime Userguide, not very much and not very deep.The best tutorial I have found is from Cisco live and the "BRKNMS-2848 - Prime Infrastructure Deep Dive (2015 San Diego) "Just r...
I have a simular tought or problem... Although for the 3.0Is there a way to add third-party devices that doesnt speak snmp... The only thing I want prime to do is to poll these by ICMP ping and worn me if and when the stop replying...Ofcourse the PI ...
Not 100% sure its related but there is a note in the "Quick start guide" about Chrome 44... Not sure if Google fixed it for the 45... "If you are using Google Chrome version 44, you may get an error that says “ERR_INSECURE_RESPONSE”. This is a knownC...
