Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are configuring a Cisco 7925 wireless phone to connect to our CISCO CUCM phone system. The wireless phone needs to pull a configuration file from the phone system via TFTP but I need a DHCP option 150 to be configured on the Meraki wireless to poi...
Using a Cisco IP Phone model 7962 - all users attempting to dial in to a Google Meet session upon entering the PIN for the meeting are prompted to enter the PIN and press enter. This repeats with no access. If a cell phone is used the PIN is accepted...
I have verified via - Management - Licenses - base-ap-count permanent No Expiry 25 Medium In useWe have 17 AP's. We needed to reboot the switch and when it came back online we observed 9 AP's were missing from the Wireless list. We had this same iss...
I thought a setting for Option 150 may of been be available in the web based Merak cloud managed AP page. I don't have local Meraki switches only AP's. I used a bridge mode setting in the Meraki cloud wireless AP website. The wireless IP phone then h...
My AP's AIR-LAP1141N-A-K9 I tried executing your offered command - those parameters don't exist. Here's a ? at config prompt for AP: =~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2020.02.27 08:18:38 =~=~=~=~=~=~=~=~=~=~=~=ap ?802.1Xuser Configures the dot1x user...
