Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,
I have ISE server and I am using dot1x to authorize users based on LDAP group. I want to make a double layer of authorization. When the user plug the network cable to the PC the PC should be authenticated and authorized as a domain ma...
Hello All,
I have two separate networks and I have one Cisco 5508 WLC with 8 ports. Can I use the WLC to manage the access points in both networks?
Notes:
I will connect 4 ports to each network.There is no any connectivity between the two networks....
I think Cisco ISE uses the Cisco-av-pair attribute for CoA, and I am not sure is Aruba WLC can understand this attribute or not.
CoA is planned to be used in Guest portal and Device provisioning and posturing portals.
Hello Kaisero,
I thinks that there are some commands to do so. I already have two FTDs and I registered one of them with the help of Cisco TAC engineer via CLI but unfortunately I forgot to log the session.
Hi Francesco,
Thanks for your reply, As i mentioned in my upper post, I have two separate networks one for Data traffic and the other one for internet traffic and there is some business restrictions to connect the two networks together.
I only hav...
Hi All,
I just want to add a point to andrewswanson answer.
After applying the above solution, the problem was fixed abut when i performed ISE-AD health check the NTP test didn't succeed however it's working fine from the CLI.
Then we found that ...
