Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All
can anyone help to provide BGP configuration that can implement failover between 2 ISPs,
i have BGP session with 2 different ISPs, i am receiving the default route from them, and i am advertising my network to both ISPs.
sh ip bgp
Netw...
hello
i need your inputs on my scenario, where i have 2 differents vlans, and which have access via a FW Cisco ASA 5520,
Cisco ASA 5520 has 2 outside interfaces connected to internet.
i have 2 default routes pointing to 2 gateway with different met...
hello Team
can any one help on the configuration that match my final expectation, i have 2 outside interface on the ASA 5520 (outside and outside2), the default route goes to outside interface.
in my LAN i have 2 different IP range(X.X.X.X/24 and Y...
Hello Dears
kindly assist on possible cause on below BGP issue. BGP session failed to be established with below error
name proto table state since infoXXX BGP master start 10:23:26 Idle Received: Malformed AS_PATH
a...
hello
i have an issue of Access Point is unable to join the wireless controller with the attached error.
assist me to solve this issue.
thanks for the cooperation.
regards,
Janvier R.
Thank you for replies.
but apart from the nat solution, there is no other way on the 5500 ASA legacy, as i am not planning to change to new ASA 5500-X in few years.
regards,
Janvier R.
hi Julio
Thanks for the reply.
-The session was established before but suddenly it is stopped.
-no change done on my side
-no ACL implemented blocking port 179
-it is an eBGP connection
find BGP configurations of peer
neighbor IP ADD remote-as XXXX n...
issue solved.
i have changed the time zone of WLC, and now the AP is able to join the WLC
find the link i have used
http://nostringsattachedshow.com/2012/02/02/multiple-country-codes-with-the-cisco-wlc/
