Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Can you please help with the following.We have a Cisco Secure ACS v4.1. A number of Groups have been created under the "Group Setup". Each group has a number of users in it. The Password Authentication is ACS Internal Database. I cannot se...
Hi all,We have 12 Catalyst Blade Switches 3020 for HP running IOS Version 12.2(55)SE. In the configuration of these switches I see the statement shown below.no spanning-tree vlan 34,45-55,70,600,643,840,843-850The 12 blade switches are configured as...
Hi,I want to check whether packets are being dropped on a FWSM interface. How to do this? I was reading some Cisco documentation and the 'packets dropped' shown under the interface is not what I thought it meantInterface Vlan100 "backbone", is up, ...
Hi everyone,I have two new Cisco switches connected to each other with a fibre cable.Does anyone know any CLI commands to test the fibre cable from any of the two switches?(I know there is the command "test cable-diagnostics ... etc". But, this only...
Hi, does anyone know if it is possible to use two different load balancing methods at each end of a port-channel between two switches? We have a Cisco 6509 at one end of the port-channel and a Cisco blade switch 3020 at the other end. Right now, we ...
Hi,Thanks for your answer. No, I don't want STP to be disabled. On the contrary that's what worries me. That's why I said in the post above that I did not run the command "no spanning-tree vlan ...". One day when I saw those statements in the co...
Hi,The SFPs we are using are the traditional ones. They are 1000BASE-SX. They don't have an DOM capabilities. I can't see any Trasmit or Receive levels. That's it. There is nothing I can do at this point. In any case thank you very much for yo...
