About YHam

YHam · 03-07-2025

Hello everyone,We currently have a non-Cisco/3rd party identity solution and are planning to migrate authentication (via 802.1x and MAB) for wired and wireless users. For wireless, we have approx. 50 WLCs deployed across different locations. For wire...

YHam · 06-08-2022

Hello Everyone,I'm trying to configure syslog and have a question on Syslog Monitoring Destination Group. It has options to enable/disable Local File Destination and Console Destination. Please see the screenshot below. It seems they are same as logg...

YHam · 05-23-2022

Hello everyone,I was going through a best practices document and found a few recommended settings below which are not currently implemented in our fabric. Could anyone tell what will be the impact if I enable following options in pod?1) enabling encr...

YHam · 04-19-2022

Hello Everyone, I have an access to dCloud however I can only do some much in dcloud lab as it runs ACI simulator. Does anyone know some good rental rack services for practicing Cisco ACI features such as L2out, L3out, VMM domain etc? (not sure if th...

YHam · 04-17-2022

Hello Everyone, I have access to Cisco dCloud and trying to practice 'Getting Started with Cisco ACI 5.2 v1' lab. When I log in to Leaf or Spine switches, i can't run NXOS style commands. I tried logging/ssh in to Leaf directly and via Apic but same ...

YHam · 03-10-2025

Thanks again. Regarding validated ISE configuration for the Wireless, do you thing migrating only one or few WLCs (phased approach) can create issues as wifi users may move around?

YHam · 03-07-2025

@Scott Fella @marce1000 Thank you. I really appreciate your input.Do you start with Monitoring mode before turning on Low-Impact or Close mode?Any rough estimate on the time required to migrate around 50 WLCs? I understand its difficult to answer wit...

YHam · 03-07-2025

Thank you Scott. Why do you prefer wireless first over wired?

YHam · 06-11-2022

Thank you, Robert.If they are enable by default, how can I see logs on leafs and spines? It seems 'show logging' command is not available on ACI switches (unlike IOS or NXOS based switch)?

YHam · 05-29-2022

Thank you, RobertCan you please also comment on my follow-up question on Options 1, 2 and 3 as below? You previously stated "Options 1, 2 and 3 have little to no chance of impact when enabling " so I'm curious which of them have possibility of little...

Member Since	‎04-07-2020 11:09 AM
Date Last Visited	‎03-16-2025 07:31 PM
Posts	20

User Statistics

User Activity

Migrate from non-Cisco/3rd Party Identity solution to ISE

Syslog Destination Group - what is Local File and Console Destinations

ACI best practices - Traffic Impact of enabling features

3rd party Rental rack to practice ACI

dCloud ACI Lab - Can't run NXOS style commands on Leaf or Spine

Re: Migrate from non-Cisco/3rd Party Identity solution to ISE

Re: Migrate from non-Cisco/3rd Party Identity solution to ISE

Re: Migrate from non-Cisco/3rd Party Identity solution to ISE

Re: Syslog Destination Group - what is Local File and Console Destinat

Re: ACI best practices - Traffic Impact of enabling features