Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I noticed something strange and wanted to share with the community and see if this someone has some info about this behavior. We have a daily Snort Rule Update set on the FMC ( probably not the best option - now I am thinking that weekly would be...
Hi, I just noticed something on our ASAs and was wondering if someone have seen this or if there is a better ezplanation for the difference between traffic(packets and bytes/s ) reported by an ASA on its Physical Interfaces number and nameif. Belo...
Hi,Recently we added zScaler IPs to our existing Local LAN Access ACL. The idea was that since this ACL is a split tunnel exclude it will exclude the zScaler IPs as well. This way RAVPN users will have their HTTP/s traffic protected by the cloud prox...
Hi,I have a few users where their Anyconnect randomly reconnects - I have troubleshooted and believe it is related to the DPD but it do not make any sense to happen on just a few users. We have reinstalled their Anyconnect Client. Below is the part o...
Hi,Is it possible to apply PBR on the dmz interface(on ASA 9.8(3)) and use it to re-route traffic directed to the inside interface but change the destination IP address in the process. Basically we need to temporary change the destination(redirect)...
Also make sure both sides are set for Route based. I have seen this with Azure - manualy go over the VPN configuration in Azure and make sure Route based is in use in Azure or vise-versa.
@Marvin RhoadsCan you share why 7.2.6 was marked as bad version very soon after its release and not recommended ?All I could find was some SNTP issue with the diagnostic interface - but is there something else ?
Do not update the FTDs to 7.3 but skip to 7.4.1 directly (or use 7.2.6).Anyconnect is end of live ( no new updates will be released) but it still will be supported for 3 more years :"Application software support will not be available for the stated s...
