Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, Need to achieve L2 layer communication for some Dante devices and my connected PC which are on the same subnet but in different VLANsI attached my plaintext so would like to ask you if possible to investigate where I did mistake. I think it i...
Hi all I am writing about strange situation and do not know what is going on.I have port 1 natively in VLAN1 but want to see the same port1 in VALN2 so I set it up as untagged.When I do apply , my switch SG350-10P is getting stuck everytime.Any sygge...
HI All,I would like to ask you where I can find the option to change my SG350-10P form L2 to L3 layer?In SG300 switch it is in Administration/System Settings but if I wanna find it in my SG350-10P it is not there. Just to add I changed in my SG350 sw...
Hi all, I am new one here and I am a beginner of IT skills. Sorry If I started the topic which maybe was disscued.I wolud like to ask you where I do a mistake or what's wrong with my switch. Tried to set up inter-VLAN routing in my switch but witho...
Yes, my PC is connected to port1. But if I change all settings in switch via GUI I wolud like this port1 use as active in VLAN2 just coonect another device to be worked with others in VLAN2
Please give an answer why Tagged pots do not work in this switch. Even I want to set it I can but after I save it I can not see Tagged ports working. Only Unttaged/Excluded is visiable.
Please give an answer why Tagged pots do not work in this switch. Even I want try to set it I can but after I save it I can not see Tagged working. Only Unttaged/Excluded
