The server went down while being in use and upon attempting to bring the server up, it will not discover. Any ideas or help?
Blade will not discover, we have attempted a virtual reset through ssh and have also manually reseated the blade to attempt ...
We are trying to replace a System board on a UCS B200 M4 but we're getting the following error message: Unable to change server power state. MC Error -20 & revocation error 1002. Any idea what should I do next? Maybe it's a DOA System Board? TIA.
Hi, We need to replace a System Board on a Cisco UCS B200 M4 part 73-15862-04. Wondering were could I find a replacement procedure steps as the Cisco UCS B200 M4 Blade Server Installation and Service Note does not have that. Thanks,Roger
We tried clearing CMOS but still getting the same.Server is still getting stuck at 52 percent discovery with Fault code F0313:Compute Physical Bios Post Timeout
