Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have the requirement of DSCP marking EIGRP traffic from CS6 to AF31. I tried to use local-policy routing as per the following:!ip access-l extended EIGRPpermit eigrp any any!route-map LOCALmatch ip address EIGRPset iop TOS|DSCP!ip local poli...
Hi,I have the below config:!class VOIP match protocol rtppolicy-map QOS class VOIP priority 64!interface Tunnel255 ip address 10.255.255.4 255.255.255.0 ip nhrp authentication UbSmEbK ip nhrp map 10.255.255.1 172.80.2.2 ip nhrp network-id 255 i...
Hi,I have the attached network topology:A VPN is setup between the Branch RTR and DC Tier1 ASA. Branch WAE is registered with the natted IP of the core CM on Y.Y.Y.a. Branch users access the servers on their natted IPs Y.Y.Y.Y/16. At the Branch wccp ...
Hi,I am getting and error ont eh WAE as per the attachements. How can I get rid of this error.I have the setup where the WAE at one end is behing a PIX 7.0 and the VPNs between the branches over the internet are terminated on routers. I configured th...
Beware when downloading the OOB Server Failover license to use the Primary MANAGER MAC address in the license generation. Otherwise it will not work.Additionally make sure that time is synchronous between the CAM and CAS and that the CAM's certificat...
Thanks, direct hit Another question, I sourced a tunnel interface from a point-to-point frame relay interface, but the tunnel never came up.Any idea why!!
