Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently purchased a Cisco 881W router - however, I seem to be having some issues with it saving the running config. I configure the router and do either a copy run start or write mem, and on reboot it asks if I want to enter initial startup confi...
Hello all;I need to forward RTP traffic to an internal IP address. It appears the port range will be 10,000 to 20,000, and I cannot set up a match protocol RTP ((config-cmap)#match protocol rtp ^% Invalid input det...
Hello all. I'm looking at purchasing a Cisco 881W router, but I noticed the transmit power is only 16dBm. That seems pretty weak as many consumer grade products have a much higher powered radio. Anyone have issues with this? Feedback, ideas, etc? ...
Nailed it, changed the config register and now it saves the startup-config. I set the wlan-ap0 to ip unnumbered, and when I try to configure the AP I get this:zb881w#service-module wlan-ap0 sessionTrying 192.168.1.254, 2002 ... OpenThen hangs. on t...
Good question. I have a Broadcom 802.11n card in my laptop, I need to find the specs of the card to see what the transmit power is on that. I doubt it will make much difference, but it's just curious to me as to why it would have such low power.
