Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am attempting to configure HA across a primary and secondary data center. I am utilizing OTV in trying to stretch the controllers. I created vlan 3002 for this purpose. I am using a an interface hanging off a Nexus 2k on both sides. The 2k is a...
I am trying to establish my ibgp peering. The routers are three ip hops away from each other and we use eigrp for our igp. Nothing I have tried works. Any assistance is appreciated. I am able to ping loopback to loopback without bpg running. My ...
I am trying to configure my ACS to allow 802.11 phones to authenticate. I have searched high and low for documentation on doing this with no luck. We are using unified wireless with a mix of 5508 and wism controllers. I am able to authenticate win...
Please disregard my request. My configuration is working. I brought up the peer management interfaces and the two controllers successfully peered. I just hadn't given them enough time earlier.
After reading your fist post more closely (after submitting my first response) I removed the network statemnet from my bpg configs. I was able to ping between loopbacks. Thanks for the assistance.Now I can get on to my ebgp peerings.Thanks,Gregg
Eap method is peap. The phone I'm working with is an Avaya 3645...essentially a polycom/spectralink made for Avaya. I've compared settings on it with Cisco phone configuration and they look extremely similar.When I try to connect I get an "Invalid ...
