cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
417
Views
0
Helpful
2
Replies

8510 WLC HA across multiple sites

Gregg VanMeter
Level 1
Level 1

I am attempting to configure HA across a primary and secondary data center.  I am utilizing OTV in trying to stretch the controllers.  I created vlan 3002 for this purpose.  I am using a an interface hanging off a Nexus 2k on both sides.  The 2k is a fex off a Nexus 5k.  Here is my interface config.

int eth 151/1/23

  switchport mode trunk

  switchport trunk native vlan 3002

  switchport trunk allowed vlan 3002

With this configuration I am able to ping the peer redundancy port ip (169.254.154.253) from my primary unit having a redundancy port ip  of 169.254.154.252.  However, my Redundancy Summary on the primary shows "Peer State -- UNKNOWN - Communication Down.

My primary controller management ip is 172.20.154.250 (Vlan 1541).  The secondary (redundancy) is 172.20.154.253.  The interfaces on the Nexus switch the secondary controller connects to are both currently in "shutdown" state.  Vlan 1541 is extended between data centers via OTV.

I am looking for assistance in why the Peer State will not establish in spite of the fact the redundancy ports are able to communicate.

Thanks,

Gregg

2 Replies 2

Gregg VanMeter
Level 1
Level 1

I should have added.....my code version is 8.2.141.0.

Please disregard my request.  My configuration is working.  I brought up the peer management interfaces and the two controllers successfully peered.  I just hadn't given them enough time earlier.

Review Cisco Networking for a $25 gift card