Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello @Andreas Seidenstuecker ,you may refer the below community article, this will help for you.https://community.cisco.com/t5/network-security/fmc-ftd-10-acme-cert/m-p/5374277
Verify the NAS definition in ISE:Administration → Network Resources → Network Devices → select the Extreme controller.Confirm Device Type / Profile is correct (use a profile that supports CoA — Cisco's built-in "Default" profile uses Cisco AVPairs th...
The honest short answer is: No — buying a firewall (any vendor's, including Cisco's) does not instantly improve security. A firewall is a tool, not an outcome. Improvement comes from how it's sized, configured, integrated, monitored, and operatedThe ...
CBS110 is unmanaged, there are no logs, SNMP counters, or CLI to inspect. Diagnosis is therefore based on symptom pattern.Borrow or temporarily replace the CBS110 with any other 8-port switch for two weeks. If the replacement runs without fault, the ...
This isn't a fault — it's a documentation/feature-evolution gap. things together make it hard to find a clean guide:Pre-7.4 behavior: Manager-access-on-data-interface only worked on standalone FTDs. For HA, you used to have to register each FTD via t...
