Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A client has a MX-64 with 4 Meraki APs.The router is setup with 3 VLANS that I see on the router dashboard.default 192.168.1.1 /24Office 192.168.128.1 /24Public 192.168.254.1 /24The 24-port switch is a Adtran provided by the ISP. I ...
MX-64 user is changing to a new ISP. In a previous question, it was mentioned that a solution is to setup a 2nd WAN port.In reading and watching videos on this being done, I read 2 conflicting remarks. The 2nd WAN port needs to be disabled, as in a...
Equipment - MX64, 3 APs (Meraki, unknown model)A new client is changing its ISP. I did not install the router or APs.I did look at the dashboard and WAN settings. The WAN now has statically assigned IPs and will get new static IPs (gateway, static,...
2 new SG350X-25
Need to change the default device IP address (192.168.1.254).
Under "Getting Started" - "Change Device IP Address"
The next screen does not allow for changing the IP address (it is grayed out). It is also set to Static and the defaul...
The offices are in two buildings connected by a short enclosed corridor (10'). The 2nd building was remodeled and all network connectors were home run back to a closet.
Now the 1st building is being remodeled and a nightmare of wiring is being re...
Question in the reply above, the picture shows 2 VLANS, if the switch is replaced with a flat switch, will all devices revert to the default vlan 1?Thanks.
Thank you for that clarity. As I understand what you said - the ADtran probably does not have configured ports for the VLANs.I see devices with the 192.168.128.n IPs for Office VLan (128). Don't remember what devices (ap's or other office devices)....
Thanks. For some reason, my own mis-reading probably, when setting up the second WAN port I thought i would see a button to make this either load-balancing or failover. I am making this harder than it is. With only a few numbers for the new ISP st...
