I currently have an RV345 setup with different Vlan's, setting each port to untagged where I want to use that Vlan.  I am thinking of putting in a secondary switch like a SG250 to allow some devices on 2 different vlan's the communicate on, so if I m...

I came into work this morning to reports our internet wasn't working.  I verified our ISP connect was up and tried to connect to the device via ethernet.  I was not able to obtain a proper IP, ie got 169 IP. I power cycled the device and upon boot ev...

Hi, I am having an issue getting two Vlan's to communicate with each other VLan 1 - 10.0.0.40/24VLan 172 - 172.16.0.0/24 Both Vlan's have devices set statically and dynamically.  Devices on both VLans can ping 10.0.0.40 and 172.16.0.0.  Devices on VL...

Hi, I've had this problem with the router prior, and gave up on the process.   I am now trying to create a new different VLAN, and when I hit apply, the page reloads and the new VLAN is not applied.  See the attached picture.  Device is RV345-K9 V04 ...

I am currently trying to hook up a pre-built network system made by a third party using Cisco devices using IOS and CLI to a RV345.  The network I am trying to connect to is a vlan setup as follows : interface vlan5description Technician_VLANip addre...