Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,I need some help.I have a situation. I am configuring a 3850 switch with PnP using Prime and APIC-EM. I am using PnP profile on Prime and activating it.The PnP profile is activated and the configuration is send to APIC-EM.APIC-EM shows the...
Hi Experts,
Hope you can help.
I am stuck in a situation. I am trying to leak OSPF connected and IA learned routes to VRF routing table. VRF is in MP-BGP address family named "VPN-NETWORKS" on WS-6509 IOS 15.1.2 SY5.
Following is the config :
conf...
Hi Experts,
Hope you can help.
I am stuck in a situation. I am trying to leak OSPF connected and IA learned routes to VRF routing table. VRF is in MP-BGP address family named "VPN-NETWORKS" on WS-6509 IOS 15.1.2 SY5.
Following is the config :
conf...
Thanks for the links Nic. With your comment on database, can you further elaborate please? Could this be the cause for the reachability issue between prime and apic-em or the pop-pnp config issue.Adam, if you can please provide your inputs that would...
Hi Adam,Thanks for your response. Was the project name already defined in APIC-EM before using PI?No, we created them in prime and it automatically pushes it to prime.We tried few things in the mean time : We tried using another VM Cisco Prime 3.1.5....
Hi Adam,Thanks for responding.This is where I am at at the moment.Deployment Environment Information : - Cisco Prime 3.1.5 - APIC-EM 1.4.2 - APIC-EM / Cisco Prime 3.1 are both deployed in VM Environment using VMWARE ESXI. - Both are in the same subne...
Hi Kelly,
Hope you can help.
I am stuck in a similar situation. I did exactly what you did. This is alright for connected routes. What I am doing is redistributing ospf into bgp. The router on which I am doing this is a building router bsr and has t...
