Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using WLAN poller to collect data from access points. It is working for all the access points except C9136 access points.It gives error like this.============================================================Summary=============================...
We have observed a strange issue in our network. For any reason(change in profile) when Cisco ISE send a COA and ask to reauthenticate to an connected client on wireless controller client session is interrupted. Client tries to reconnect and we see c...
Hello,Facing an issue. We have a Cisco 3615 ISE appliance. It was set to factory default both ISE (linux os) and CIMC firmware. Now CIMC interface is not sending any ethernet packet to switch. Switch is not able to learn MAC address of the CIMC port....
Hello,This is related to AP dot1x authentication using LSC. We are trying to implement Dot1x using EAPTLS on access points. In our test setup we successfully enrolled certificate on access point using Enterprise PKI server.But when we tried to use LS...
We are seeing alarms for COA failure on Cisco ISE dashboard. When open the details of the log on ISE in the Result section Reply-Message is "No valid Session" but interestingly when we see some of the sessions using the session id mentioned in the lo...
@MSJ1 Device Sensor is dependent on DHCP snooping for the DHCP data. Just like it is dependent on CDP and LLDP to be enabled for it to collect CDP and LLDP attributes.
@voidray87 I have not done exactly the same migration but basis on my other experiences, I would like to add my inputs.1. Yes, you should use both FQDNs in SAN field. This is requirement for many services to trust the certificates and having explicit...
@merloxuanyuan23 After verifying authorization profiles as suggested by @Dustin Anderson would advise to upgrade 9200 Switch to recommended version 17.12.6 and then test. ISE logs shows it is sending auth profiles. Switch debug show ISE responds ini...
