Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
WLC added some characters in WAPs primary switch and WAPs fall back to standby-8.10.151.0 please suggest All WAPs(2700) configured with Primary WLC(8540-8.10.151.0)out of total 500 WAPs configured with secondary wlc(5508-8.2.166.0) and were working ...
cisco 9130 two ap mode is monitor mode and rest in local mode,How we can check the the scanning list and data of monitor mode ap?,, i try few commands but did not get through,, as of now I dont have just controller(8.10.121.0 and cisco 9130 aps..to c...
FYI-• Abnormal logs of "Primary WLC name" which was output by show run-config commandLink: https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvw88632 • After upgrading to 8.10, Primary Controller name appended with junk characters (Duplicate of the abo...
Cisco reported CSCvx52228 which is little bit different than this issue but corrupt the WLC name in AP configuration...checking with Cisco for outcome.
1.Is it good practice to keep same mobility group name for both anchors? note:-anchors configured with priority01 and priority-3 on foreign controllers side.2.and by keeping same name, does both share the client information?3. ISE based Guest auth(c...
Subject :- Inline upgrade Cisco Prime 3.8 to 3.9Issue:-% Unable to unbundle the package. Package may be corrupt or there is not enough disk space temp. space 1% used (3172 of 1983056)disk: 2% used (2235760 of 184561716)MD5 -matched Resolution:-Dele...
