Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have 3 sites that all have FTD firewalls. I use screenconnect to remotely manage devices at all 3 sites. The screenconnect server is out on the internet, and NONE of my other customers experience these issues. Even other clients with FTD fir...
Hello! I had an issue when I setup AnyConnect for a client on a FTD firewall using FMC. The issue was that their ISP is handing out static IP addresses to all their clients on a shared /23 network. I didn't specify no-proxy-arp, and after a few hours...
Hello, I'm using a 3rd party utility called OpManager to manage backups and monitoring of my network. I've been working with their support and I found out that my firewall's enable password in "system support diagnostic-cli" is blank. They don't supp...
Hello! I'm having issues moving the VPN SSL certificate from ASA 8.x to a Firepower Management Center controlled firewall. I can export the certificate in PKCS12 format and import that into FMC without any issues, but it only verifies the identity c...
Hey John! Thank you for that! I went back to their support and showed it to them. They're insisting that they support other firepower devices, but that they don't support a blank password. Do you know if there is any way for it to go directly into pr...
Nevermind. I'm not sure if your method would have worked. I couldn't figure out how to do that. Instead, I finally figured out how to use openssl to combine the certificates into a single cert. Thanks again for the reply.
Hey Marvin! Thanks for the reply. That sounds extremely simple, so please excuse my lack of understanding with the CA process. I see how to export the certificates from the browser, but it has different formats, and there are multiple sections in the...
