Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, we'd like to set-up workgroup bridge feature on new Catalyst 9800 WLC with transparency for VLAN-ID's (trunk via WGB) like on following link: https://www.cisco.com/c/en/us/support/docs/wireless-mobility/service-set-identifier-ssid/211293-Conf...
Hello,
we've found a strange behavior on old Catalyst WS-C2950SX-48-SI with 12.1(22)EA6, Multiple STP running (MSTP), keepalive enabled and "errdisable recovery cause loopback" enabled. Uplink switch is 2960-X.
A non-managed switch was attached t...
Hello,
can you please check the problem with our wireless network. We have a requirement to enable multicast stream among the wireless clients behind the access-points, registered on the same WLC (WLC2504).
For example, 3 clients are on the same...
Hi.
We have problems with connecting 4500-X with 3650 over 10G SFP+.
4500-X port:
interface TenGigabitEthernet1/15 no switchport ip address 192.168.200.2 255.255.255.252end
TenGigabitEthernet1/15 is up, line protocol is up (connected) Hardwa...
Hi,
I'll give a hint, how it might work - actually it worked in my case, but I didn't intend it to do so. Here is the way to change "nameif" to other interface and not lose all other configration, connected to that nameif interface.
1. you save o...
