WGB feature

[egon]

Hello,

we'd like to set-up workgroup bridge  feature on new Catalyst 9800 WLC with transparency for VLAN-ID's (trunk via WGB) like on following link:

https://www.cisco.com/c/en/us/support/docs/wireless-mobility/service-set-identifier-ssid/211293-Configure-Work-Group-Bridge-WGB-Multip.html

From what we understand, ACCESS-mode of only one VLAN is possible on version 16.12.02s?

wireless profile policy test-wgb
aaa-override
no central authentication
description test-wgb
idle-timeout 3600
session-timeout 300
vlan 49
wgb broadcast-tagging
wgb vlan
no shutdown

WLC(config)#wireless profile policy test-wgb
WLC(config-wireless-policy)#wgb ?
broadcast-tagging Configures WGB broadcast tagging on a WLAN
vlan Configure WGB vlan client support

WLC(config-wireless-policy)#wgb vlan ?
<cr> <cr>

WLC(config-wireless-policy)#vlan ?
WORD Enter Vlan

Best regards!

[Grendizer]

You need those commands as you mentioned. The VLAN you set it up for the policy profile is not used, assuming the WGB will connect to a switch by trunk, the wired clients will use whatever connected switch switchport VLAN configured but you need to define those VLANs from the WGB AP.