Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm doing some L2 cleanups across mutliple 6509E environments and I've found something consistent that I can't find in documentation. On all my pairs of 6509s where I have FWSMs bundled (6509-A has FWSM-1 is Slot 1 and 6509-B has FWSM-2 in Slot 1) I ...
I'm pretty sure the answer is "NO" but is anyone doing any kind of Nexus emulation (legally) for training/learning purposes?Dynamips - NOI.O.U. - NO (I think)Others?If this isn't the right forum please redirect me. Thanks.
All, I have an interesting challenge. I have an existing monitor session set up as below for monitoring on a 6509. I have a single monitor session with multiple egress interfaces based on the VLAN. This solution works very well for feeding specif...
Does Cisco have an official position regarding support of undocumented commands in IOS?example:bgp bestpath as-path multipath-relaxIt's a hidden command but works great when I lab stuff up. I've never used hidden/undocumented commands in production. ...
Recently there was a debate among some folks about how STP is handled within an Etherchannel. I understand that once an Etherchannel is defined, regardless of PAGP or LACP, that the new port-channel is introduced into the spanning tree and the physic...
So is there a difference between the NXOS you would run on a Nexus 5k or 7k VS the NXOS you would run as an instance on a virtual supervisor on a 1000V? I'm guessing it's not the same? BACKGROUND: Basically what I'm looking for is something similar t...
It's a loaded question.Do you use truly use LACP for thruput gains or link redundancy? In our case, my focus in the design is link redundancy. I always scale to N+1. So in the event of a cable failure (rare but it does happen) I don't sacrifice thrup...
