Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I use a Cisco AIR-AP1832I-F-K9 with Mobility Express 8.10, but when it is turned on the 5 GHz frequency with the AC band or 802.11 ac protocol does not turn on.when turned on the signal is only detected with band A or the 802.11a protocol only and th...
@patoberli wrote:I currently don't have an ME AP to test here. What shows the GUI in regards to the enabled speeds?Have a look at the best practices in the GUI, but don't enable everything, not all functions are indeed best practice. But you should s...
@patoberli wrote:This looks good.What is the output of this command:show controllers dot11Radio 1Can you also test a second, different client, just to verify it's not an issue of the client?My Cisco AIR-AP1832I-F-K9 Firmware is mobilty express versi...
@patoberli wrote:It's all in the 5 GHz range.Did you enable the new speeds on the AP?Can you try it with an SSID without encryption?No, i didn't enable it, and i was trying to create new SSID without encryption but the result is same
@Karsten Iwen wrote:Do you have TKIP enabled? Then it is expected behaviour. Just disable it and enjoy full speed.no, i haven't enable TKIP, and I tried to scan my wireless network using 5ghz AC usb wifi and the result was that the network that appea...
