hi
i have cisco c888-k9 router that does not have ethernet0 interfaceso I can not configuerif i do a show ip int brief or show version, the ethernet0 interface does not appear
hi,
on the router that is causing it, if i do the command show version i get this :
cisco C888-K9 (revision 1.0) with 357452K/35763K bytes of memory.Processor board ID FJC2116L0YL1 DSL controller4 FastEthernet interfaces1 ISDN Basic Rate interface1...
thank you for answer
but the command controller shdsl 0 or controller DSL 0 doesn't work
i know the cisco document But it speaks of a cisco 888EA and not of the c888k9
it doesn't work also with ATM
Current configuration : 5575 bytes!! Last configuration change at 08:12:35 UTC Thu Dec 29 2016 by ciscoversion 15.3service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption...