ethernet0 missing on cisco c888

[bertrandcazal]

hi

i have cisco c888-k9 router that does not have ethernet0 interface
so I can not configuer
if i do a show ip int brief or show version, the ethernet0 interface does not appear

[bertrandcazal]

version c800-universalk9-mz.SPA.154-3.M3.bin

[Tinashe Ndhlovu]

Post output of show interfaces please.. sorry never worked with the C888.. but providing output of the show interfaces should be enough to ID the issue

[Georg Pauwen]

Hello,

which Ethernet0 port are you missing ? The 888-K9 has four LAN ports, FastEthernet0 - 3, and one FastEthernet WAN port, FastEthernet 4.

Have a look at the attached image - which port is not showing up ?

[bertrandcazal]

hi,

on the router that is causing it, if i do the command show version i get this :

cisco C888-K9 (revision 1.0) with 357452K/35763K bytes of memory.
Processor board ID FJC2116L0YL
1 DSL controller
4 FastEthernet interfaces
1 ISDN Basic Rate interface
1 terminal line
1 Virtual Private Network (VPN) Module
DRAM configuration is 32 bits wide
255K bytes of non-volatile configuration memory.
254976K bytes of ATA System CompactFlash (Read/Write)

on the router that does not have a problem, if I do the command show version I get this
Cisco C888-K9 (revision 1.0) with 357452K/35763K bytes of memory.
Processor board ID FGL1851206X
1 DSL controller
1 Ethernet interface
4 FastEthernet interfaces
1 ISDN Basic Rate interface
1 terminal line
1 Virtual Private Network (VPN) Module
DRAM configuration is 32 bits wide
255K bytes of non-volatile configuration memory.
250880K bytes of ATA System CompactFlash (Read/Write)

[Mark Malone]

There 2 different physical outputs , the 1 that does not have the problem has an extra hardware Ethernet port , what are trying to setup a lan or wan port , the original looks like its only able for 4 lan ports plus 1 dsl wan port , while the working one has 4 lan 1 wan Ethernet but also a dsl wan , your missing a port if this is a like for like replacement

1 Ethernet interface

[Georg Pauwen]

Hello,

check the physical back of your routers...is there an Ethernet 0 interface in one of them and not in the other ? Ethernet 0 is tied to the DSL...

Can you post the running configurations of both routers ?