Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning all. I'm currently in the process of upgrading from a 2921 to a 4331 (there probably isn't a great deal of difference between the two however I managed to acquire one lol) anyhow i'm struggling to get a internet connection. I copied the ...
Hi all Quick question, i have a 2921 with a 8 port EHWIC module and a 9 port HWIC module. The 8 port works fine, the 9 port works fine (when it was in the 8 ports location slot). I've move the 9 port to subslot 3 (from 1 where the 8 port is located...
Good morning all Potentially a quick question (alothough apologies if it turns out to be a long one). I have a 2921 with a 8 Port GE POE EHWIC Switch module. I also have a 2811 (acting as a switch) which i'm wanting to remove and just use the 2921....
Good morning all First post so please be gentle I've been out of the Cisco game for several years now and have just setup a homelab to brush up on my skills (potential job change). Anyways to the problem. My current setup is as follows: Netgear C7...
Hey Paul my bad, i was using my DNS server address which currently isn't connected so when changed to 8.8.8.8 it now works. apologies for that, school boy mistake that one. Thank you very much guys for your help
No problem @Georg Pauwen managed to get that part sorted and in response for your last part, no the clients can't seem to get to the internet. they can ping the gateway (so in the computer i'm testing it on 192.168.4.1) but can't get to 8.8.8.8 f...
Thank you guys, so removed the acl part and also did the bits in bold from you suggestion @Georg Pauwen . From the router I can now ping 8.8.8.8 which is great (again thanks for that). The only bit I couldn't get to work correctly was the:
access-l...
