Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have problem with power consumption of switch Cisco Catalyst 2960S-48TS-L. There is max. consumption 52W in 100% utilization in datasheet, but I measured 90-100W power consumption with no load. Problem is that UPS time of this switch is half of ...
Hi, I have 887VA router and trying to configure VDSL internet connection.VDSL is working, but no IP address is set.In interface Ethernet0 I was trying to useip address negotiatedand alsoip address dhcpbut no one gives me IP.Internet is working on ano...
Nobody had problem with power consumption of Cisco switch?My "test case" was running 2960S-48TS-L (at 230VAC) with only 2 ports connected (interface Gi1/0/1, Gi1/0/2), both at 1Gbit speed. Power consumption was measured 90-100W with zero switch load....
Wattage in datasheet for 100% Throughput is 52W. So it should be maximal value. There is no stacking or SFP module installed.https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-s-series-switches/data_sheet_c78-726680.html
Yeah, that's what I really like on administration. That feeling after solving problem. And drink (now Pilsner Urquell beer) after successful finish. Thanks for your help and patience. Juraj
Problem solved.Only problem was the VLAN ID for VDSL LAN (not 101, but 2510). I found it on T-com pages: https://www.telekom.sk/wiki/internet/zakladne-nastavenia-sieteCorrect config is attached.Thanks for your help
Paul, I don't think, it's correct configuration. Please, correct me, if I'm wrong. 1. As I understand, ATM0 interface is only for ADSL connection. I'm using VDSL2 Annex-A.Here is info about my connection from my old Asus router: DSL ModulationITU G.9...
