Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,There are two L2L vpns to 2 different partners configured on the same Cisco ISR4331 router. Now, beside the other traffic (to the lan of ISR4331), the 2 partners needs to communicate to each other like PartnerA -L2L-> ISR4331 -L2L-> Partne...
Hi guys,I have the following scenario: Site to Site vpn with NAT configured on local cisco router like bellow (remote network not managed by me)Outgoing vpn traffic is overload NAT-edip nat pool NAT_POOL 10.62.15.67 10.62.15.68 netmask 255.255.255.24...
Hello all,I have to configure an IKEv2 site to site vpn on a Cisco ISR. So far everything ok.The problem is that I cannot use internal IP subnets as they are overlapping with the remote ones. I want to configure NAT for this vpn and to translate traf...
Hi, yes, that it should work for sure, but unfortunately I cannot use VTI for these L2L vpn. Remote ends are not under my management and VTI solution is not an options.Both L2L are using crypto map on the same interface on ISR4331.thanks anyway
So applying the ikev1 solutions seems to work just fine. Additional lines of config: ip nat pool INSIDE_GLOBAL_SUBNET 192.168.186.2 192.168.186.251 netmask 255.255.255.0ip nat inside source list TRAFFIC_TO_BE_TRANSLATED pool INSIDE_GLOBAL_SUBNET over...
This is the current config without NAT. Any help please to make NAT work in this case? IKEv2 configuration looks like:!!!crypto ikev2 proposal PROPOSALencryption aes-cbc-256integrity sha256group 16!crypto ikev2 policy POL_IKEv2proposal PROPOSAL!crypt...
