Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After making a number of changes to the QoS engine on our core switch some of the police policies are now malfunctioning.
A policy that is supposed to limit bandwidth to 50 mb/s is only allowing .1 mb/s while other policies work fine.
Hardware reb...
We have an old Nexus 5020 we are trying to setup in our lab.
We want to setup a Trunked 2x wire 1gb/s etherchannel between the Nexus 5020 and a stack of 3750 switches.
The Nexus has 2x GLC-T transceivers plugged in to give us 1gb/s ethernet for the ...
We are trying to setup QoS Bandwidth policing by subnet but the policies we've defined aren't getting any hits. Only the default policy is applying.All of our /24 subnets terminate on the 3850 stack, we are trying to police bandwidth inbound/outbound...
Wondering if anyone has run into something like this before.We have an ASA cluster acting as our network firewall.We are using the ASA to NAT public IPs 1:1 to two different internal servers.
Most of our servers are attached to a Pair of Cisco Nexus ...
We will check the serial #s on the SFPs as soon as we can, that would explain a lot if it's this specific bug.
It's just annoying because we don't have access to our FEX's yet. Otherwise we wouldn't need to use the adapters at all!We will try to dig ...
With Negotiation off:
NX_01(config-if)# do show int eth 1/1Ethernet1/1 is down (SFP validation failed)
With Negotiation back on:
NX_01(config-if)# do show int eth 1/1Ethernet1/1 is down (Link not connected)
yes, only the first bank of ports are 1000/10000. I found that out already
NX_01# show int eth 1/1 transEthernet1/1 transceiver is present type is SFP-1000BASE-T name is CISCO-FINISAR part number is GLC-T revision is 10.0 serial nu...
