This can be achieved by PATAs per your packet flow it will be traversing over VPN and reaching to R2 there it will be decrypted.Then u need translation so that 192.168.0.0/24 subnet gets translated to 192.168.10.1 it can't be translated to 192.168.10...
In dual ISP setup while using IPSEC we have following conditionsL2L can work on primary ISP as well as backup ISPIPsec with mobility it will only work on primary ISP , if primary goes down then on backup ISPShare the following infoSh run | in ip rout...
Here is the solutionBy default the weight parameter is 0.so, what u can do , on both the routers for their ebgp neighbor assign a weight of 1000ExampleNeighbor weight 1000Why its not recommended to set weight using route-maps, in case of dual ISP se...
In this case "weight" is the ideal match because each site has to route the traffic via its local edge router.The IBGP is acting as backup.Sent from Cisco Technical Support Android App