Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Plain and simple what are the best ways to handle PCI compliance over a wireless network. The first person that says create a seperate SSID will not get rated ... Mainly in regards to: Segment the wireless network from other network traffic (Section...
I am the process of developing a wireless guest splash page although I can not find a good deployment guide. I would like to provide a solution for guest clients to accept terms of agreement using HTTP not HTTPS. I also would like to see a splash pag...
I have seen many releases of NCS code along with many caveats. What do you fellow engineers believe is the most stable and recommended version to be running right now?ThanksTom
Although I have the 1mb data rate disabled on the controller I still see lots of 1mb traffic while performing a packet capture. How and why is this occurringThanksTom
What is the average memory usage for a Cisco 5508 with 500 APs (mostly 3502s) running 7.0.116.0 code? I am currently at 450 access points and have 80% memory usage should I be concerned?
I am pretty sure the session time out would only work if you have a splash screen. Since this time out dosent kick the users off but makes sends a reauthTom
Reset the access point back to default. You can do this VIA the controller or by holding the mode button.I also suggest confirming this command has not been issued (Cisco Controller) config>ap led-state disable allThanksTom
