Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
probably a real stupid quesiton...i have successfully backed up a config from an old 3560 cisco 48 port switch. simple commands, copy start tftp, then follow the prompts. all tihs after setting up proper ip addresses and masks and ensuring that the...
a bit confused, so what version of IOS am I running? I see 16.12.04 and 16.12.4. i see the name of the ios as cat9k_iosxe. thanks. show verCisco IOS XE Software, Version 16.12.04Cisco IOS Software [Gibraltar], Catalyst L3 Switch Software (CAT9K_IO...
HI All On an access switch with no routing protocols turned on. why would there be an default route command? (ip route 0.0.0.0 0.0.0.0 192.168.1.1) there is a routed port on the switch with the ip add 192.168.1.2/24. my thought is you need a DEFAU...
Hey All I'm swapping a cisco 3650 for a new cisco 9200 switch. the existing switch connects to an ASA, and then also connects to other switches. I unplugged the old one and plugged in the connections to the new switch. I could not get internet co...
Hi All Got a weird one for you. thought someone on here might have an idea of what is going on or can point me in a direction. haven't seen this before. interface is active, connection is up. nothing is listed in the log for the switch on gig1/...
Here are parts of the config that are different:RUNNING CONFIGcrypto pki certificate chain HTTPS_SS_CERT_KEYPAIRcertificate self-signed 01308202D1 3082023A A0030201 02020101 300D0609 2A864886 F70D0101 040500306D312930 27060355 04031420 50445F74 170D3...
do you take the running config OR the start up config? which do you chose when copying to tftp?when i do a side by side comparison, there are parts of the configs that are different, even after i've done a copy run start command.
hey all. thanks for the replies.i got it working. the sfp module was not lit up, so i reset both ends of the connection and the light came on. layer 1 issue i guess. the settings were the same betweeen switches. if yours is not working make sure...
