Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I just booked an "Cisco Catalyst Center 2.3.7.9 Release" Sandbox environment.
I got the mail, I can connect to the VPN, I can even login to the CML: IP: 10.10.20.161 with credentials.
But why I cannot login to the center??
Cisco Catalyst-Center...
Hi experts,
I know the way to change the IP state on "general-IP Config", but my query is that can we do that for all the APs on WLC together?I have hundreds of APs. Additionally, the DHCP server is in Linux server, not on the WLC. Thanks in advance...
Hi all,
I want to add some allowed
vlan (3400,3410,3420)
in uplink port on
switch WS-C2960X-24PS-L
and use this command
##switchport trunk allowed vlan add 3400,3410,3420
Why it comes with this:
interface GigabitEthernet1/0/24switchport trunk allowe...
Hi all,
Background:
I have two WLC 5500, which were performed in HA mode, but I just disabled the SSO in primary just now, and then the secondary went to the maintenance mode.
Issue:
When I want to make them back to the HA mode, I found that I forg...
Hi guys,
The AP 3802E have 4 ports(A\B\C\D) to connect to the external antenna. My question is that can these four antennas can work independently, or in group?
For examples, like A+B+C+D, or AB+CD?
Update: I can see something now, but the page response speed is extremely slow... This is completely different from the exeperience in an SDWAN enviroment....
@Ruben Cocheno wrote:
@DavidZhang47328
If you change the config to static on the WLC, it will push the config out to every AP. Now you can change all APs in one go using the CLI onf the WLC.
I personally prefer to use reserved IPs on the DHCP and as...
