Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have some PoE issue. The Cisco 3560-CX PoE suddenly doesn't provide power on all ports, but any device doesn't need power has no issue. data flows well. Only CCTV cameras connected don't get power at all. Below is the switch log and some monitoring...
Hello experts, We have two APs, A in main conference room and B in small conference room and there is drywall between two rooms, but the both APs are very close in distance, maybe 20feet. From last week, we have employees work in both room due to co...
So, diagnostic results show failure status is a hardware issue? We have no Smartnet for this. We have 3 more switches bought at the same time, need to act preventive action. What could cause this issue? the switch is connected to PDU ->UPS.
I also did a diagnostic test. it records below "TestInlinePwrCtlr{ID=7} has failed. Error code = 0x1 (DIAG_FAILURE)". Does this mean it's hardware failure? Sep 14 19:40:55.387: %DIAG-6-TEST_RUNNING: Switch 1: Running TestPortAsicLoopback{ID=2} ...Sep...
I disabled the channel 2.4Ghz on AP1 after I see the interference grew with rogue AP. The additional thing that I found was either I had to change preferred channel for everyone to 5Ghz or disable the 2.4Ghz in AP. When even single client uses the t...
Yes we are facing issues with AP 1. users say they get disconnected multiple times ( once every 1 or 2 hour) a day.I checked the log (how ap eventlog Cisco_AP) but it shows only log about client connects, nothing like AP down or client get disconnect...