Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i have an rvl200 Router and the ssl-vpn-tunnel is working fine under windows and linux.Now i bought a Nexus S with Android 2.3.3 and would like to create an vpn-connection to my router too.But the Applet, like on linux is not starting.Has anyone a...
Hi,i bought a new SG200-26P for replacing an unmanaged Netgear switch. Since that, one of my phones, the SPA941, is flashing the mute button very often. Phoning is possible, but it is annoying. I switched green ethernet for this port of and putted th...
Hi,i bought a rvl200 last week and installed it last weekend. After using the router approx. 1 hour the router crashes and does not work anymore. I need to disconnect the router from power. Does anyone knows if this is a configuration problem or a ha...
Hi,i will be aborad for 3 months an will call into the home phone net over my spa9000 system. I have a wrv200 router and we are using nat translation. Which ports do i have to open for registering a softphine like x-lite to the spa9000? I will try th...
Hallo,i have a spa9000 and the gateway spa400, telephone provider is cable germany (Kabel Deutschland).Nearly every second or third phone call ends after 5 minutes. One telefon shows the ip code 701, which means that the the person which i have call ...
Hi Florian,i tried several setting at the switch, but i haven't found a solution.I do not use this kind of phone directly at the switch anymore. The cisco phone spa922 works without any problems with the switch. If you put any other switch between, t...
Hi Shaun,i called the cisco hotline. They told me to reinstall the firmware with the effect that the router crashed while updating and had no functionality after this. Then the replaced the router. I got today a new one and it workes fine.Hope that h...
Hallo Alberto,i had several phone calls with the cisco support germany ( Martin Raykov).We have found out, that the caller-id configuration in the way it is discribed in another articel in this forum, is the problem. At spa400 the callerID Method mus...
Dear Alberto,i have configurated the system with the wizzard first. Then i changed some parameters according to the Caller identification like it is mentioned in this thread hear. The Wizzard has the version 2.1.1.2.Kind Regards,Tobias Lorentz
