Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Folks,
we use ISE PassiveID identity sharing from ISE to FMC for uset-to-ipaddress resolution vis pxGrid. There is also machine dot1x authentication using the sam ISE as Radius/AAA.
It happens that username-to-ipaddress event from ISE PassiveID is so...
Folks, do you have any experience with running ISE VMs on Hyper-V cluster. Is that supported setup at all ? We are running 2 ISE VMs in primary/standby setup. We found that PassiveID function doesn't fail over automatically when primary node fails. S...
Hi, did you make KB working in System Utilities . I have the same issue with ISE 3.1 VM on Hyper-V. I cant reset password as I cant select the option by typing the number. At the initial boot menu and after ISE boot KB is working normally.
Hi @hazayed ,Thanks for the document. I know this chain was written some time ago. However do you have an update how it works in clustering design in 7.3 . I found for example I can't configure sNAT/dNAT for the probes dependently for each FTDv devic...
Diaz,
thanks for the reply. I understand the behaviour of FMC user sessions. However still missing 2 points:
1. The machine name detection happens 30 minutes after dot1x session has been established. It most likely comes from a Radius accouniting mes...
