Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I need some help in creating that ACL on Cisco multilayer switch. 1) I want to allow all traffic between these subnets10.75.0.0/22 ------ 10.0.0.0/8 2)) I want to allow only http traffic and block the remaining traffic between the following subnet...
Hi I am planning to configure Cisco UCSM Backup . If I select "Policy Backup and Export " and set weekly then its mean it will take Full state and All configuration backups on weekly basis . I have three questions about it . 1) When i configure th...
Hi I am trying to get tech support file for a specific server in Cisco UCS Manager . Its been 3 hours since it is showing the status in progress and in the events section i found this timeout error [FSM:STAGE:REMOTE-ERROR]: EXTEND-TIMEOUT:Result: ex...
Hi I have setup of 10 UCS C series setup in my Cisco UCS manager. Server 9 and 10 are recently added but it shows some issues of Dimms , CPU etc . can someone please tell me how to download a log file for that specific server 9 in cisco ucs manager. ...
Hi Thanks for the reply . Actually The communication between these subnets is happened only in this SVI ( interface vlan 2) so thats why i want to apply ACL on this interface. 10.75.0.0/22 (source )------ 10.0.0.0/8 (destination) 2)) I want to all...
Thanks a lot . I started it and after some time it throws me a timeout error ( but tech support file still showing in progress ) ? . Do you know roughly how much time it would take for one server ?
Thanks a lot . I started it and after some time it throws me a timeout error ( but tech support file still showing in progress ) ? . Do you know roughly how much time it would take for one server ?
