Hi!I have a question regarding 6509 config:interface Vlan33 ip vrf forwarding old_lan ip address 10.4.2.1 255.255.255.0 ip helper-address 10.10.1.2endShould I configure the ip helper-address in a vrf or will it understand that the helper must look fo...
Hi!I wonder why I get such a route on my ABR:O*E1 0.0.0.0/0 [110/10067] via 10.47.0.7, 00:05:52, Serial0/0This router is connected to backbone area and area 1. Serial 0/0 is assigned to area 1 nssa only.Also, do I have to have only one exit to the ba...
Hi!I just wondered about this:P 10.26.0.0/24, 1 successors, FD is 284160 via 10.12.34.2 (284160/281600), FastEthernet2/0 via 10.12.0.2 (307200/281600), FastEthernet0/1Why the FD = RD + 256*Delay, but not FD = RD + 256*Delay + 256*(10000...
Hi Atif!Thank's for your reply!Turns out that 6k supports only ip-helper in global table. I opened a TAC case and they told me that this won't work (server is in the old_lan vrf). So seems that with catalyst it requests the IP on the global routing t...
Hi!Oh, I did not know that only one ABR can translate from Type7 to Type5 (and vice versa, too?). Then it makes a lot of sense, except the fact that my serial link is a part of area 1 (NSSA).I attached a picture - there you can see the topology R8 g...
