Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We currently use the following script to reset the PRI when it fails. This works fine, but sometimes generate dozens of alerts when the link is flapping. I am trying to build a script that won't generate more than one email every five minutes. Here i...
We currently have an IP SLA tied to EEM scripts which work great for sending syslog messages for alerting purposes. However, I'd like for each router that sends a syslog to send its hostname using wildcards instead of the hostname specified. I am g...
I have a pair of 3945E routers I use as redundant VPN head-ends in our data center and numerous 2901 and one 2951 used as spoke routers. Each of the spokes is connected to the 3945's over VTI tunnels three and four. We regularly see replay errors o...
Hello,I put an SSM40 into production in our ASA last week in promiscuous mode initially to determine what the device is seeing inbound through the ASA. So far, it isn't reporting anything which I suspect isn't correct. This is what I have for a con...
I'm experiencing a failure on headend 3945 routers with VPN tunnels to remote 2901 routers. Essentially, a tunnel a a 3945 will go down/down although the tunnel on the remote router indicates it is up/up. It happens intermittently and I am not seein...
This is a great article, but can HA-NAT be used to load balance traffic between two NAT routers, or can GLBP be run in conjunction with this? If so, can you provide example configs with GLBP?
It looks to me that you can set up discriminators on IOS routers to do what you're wanting. The global config command is:logging discriminator discr-name [ [ facility] [ mnemonics] [ msg-body] { drops string | includes string } ] [ severity { drops ...
