About suporteUNISIM

suporteUNISIM · 06-10-2022

Hello, I have a 2960-X Catalyst (WS-C2960X-48FPD-L) switches with c2960x-universalk9-mz.152-7.E2 firmware (with web interface). After updating to the latest firmware available (c2960x-universalk9-mz.152-7.E6), the web interface started to show some s...

suporteUNISIM · 08-21-2020

Hello,I'm new with cisco equipment and I'm looking for some lights to solve an issue. In 2960x switches (WS-C2960X-48FPD-L), Is it possible to convert a 10G SFP+ front uplink to a stack port without loose the connection on stack port of installed fle...

suporteUNISIM · 06-13-2022

Hi @marce1000 Find below the steps to solve the problem: config tservice timestamps log datetime ip http authentication localend write memory Thanks for your help!

suporteUNISIM · 06-10-2022

Hi @marce1000 Unfortunately, it didn't work. I changed the the service timestamps log to datetime, save the configuration and restart the switch, but the problem persists. Thanks

suporteUNISIM · 08-24-2020

Hi @marce1000 Thanks for your reply. I saw this document, but it does not solve my doubt.I would like to work with my 2 flexstackplus port and my 10G uplink as a stack port at same time.And when I convert my 10G uplink into stack port, my stack port ...

Member Since	‎08-18-2020 05:42 AM
Date Last Visited	‎06-20-2022 04:30 PM
Posts	5

User Statistics

User Activity

Strange web interface after C2960X firmware upgrade

Stack 2960x with flexstackplus and 10G SFP+ uplink.

Re: Strange web interface after C2960X firmware upgrade

Re: Strange web interface after C2960X firmware upgrade

Re: Stack 2960x with flexstackplus and 10G SFP+ uplink.