Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,It appears CML platform isn't operational at the moment as I tried to launch it several times but all failed with the warning as follows.It suggests to contact "Space Admin". Anyone knows how we can reach out this contact? Thanks in advance.
Hi all,I'm testing out the configuration for an IPsec VTI Site-to-Site VPN and have successfully initiated an IPsec tunnel connection between two Cisco peers (R1 & R2) as shown below. The Tunnel interface on each router is up and running.Each router ...
Hi all,Hope you all are doing well.I have a quick question regarding the default Vlan 1.If I choose VLAN 1 not to be a native VLAN on my switches by issuing the command SW1(config-if)#switchport trunk native vlan 100. Will the default Vlan 1 be tagge...
Hi all,In the interoperation environment between an MST region and a PVST region. Let's say a root bridge (CIST bridge) is elected in the PVST region. In this case, when an MST boundary switch (Ex: SW1) sends BPDUs to another switch in PVST, what bri...
Hi all, I have been curious on how we are able to limit a Wifi access time of users. For example, a guest user is only allowed to access Wifi for 2 hours. I'd also like to know about setting up one-time Wifi password.Is the combination of Cisco WLC a...
Hi, yes it's resolved.Nothing wrong with config on all routers.It must be an issue with GNS3 as the lab works fine on Cisco Modeling Lab.Thanks for following up.Regards,
Hi M02@rt37 Confirming that R3 has a default route pointing to R1's F0/1, and R4 has a default route pointing to R2's F0/1But still they can't ping each other, which is strange.Any other opinions on this?
Hi M02@rt37 Confirming that R3 has a default route pointing to R1's F0/1, and R4 has a default route pointing to R2's F0/1But still they can't ping each other, which is strange.Any other opinions on this?
