Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello everyone
Although it's been said that you can see routers/Nexus devices interfaces associated VRFs in view360, but we can't see any vrfs on any router.
snmp and SSH configured on Prime and routers and router status is MANAGED in device inventor...
Hi everyone
we have Cisco prime infrastructure 3.4 installed in our organization. snmp v3 and ssh is configured on devices(Switches and routers) and PI. snmp access and ssh access from PI to devices are set and everything works fine and all devices a...
HelloRecently we bought a 6509 with 2 Sup2T. As we decided to upgrade IOS, we copied desired IOS into bootdisk and deleted the old IOS. Then we changed the bootvar and boot system flash path to propers IOS.after we restarts the switch it goes to SP6>...
Hello
We have an AS5300 with a 2PRI module on it. We plugged 2 E1 lines to this module. I configured E1 controllers, Line and Interface group-Async1
which contains group-range 2/0 2/17.
As soon as I configured Interface-group Async, Interface Async 2...
Hello
We have an AS5300 with a 2PRI module on it. We plugged 2 E1 lines to this module. I configured E1 controllers, Line and Interface group-Async1
which contains group-range 2/0 2/17.
As soon as I configured Interface-group Async, Interface Async 2...
According to user guid it should be possible:
Get VRF Details from Router 360° ViewThe router 360° view provides the VRF details for the following routing protocols:• BGP Routes• BGP Neighbors• EIGRP Routes• EIGRP NeighborsTo view the VRF details usi...
Dear @Mark Elsenthe problem is that our security policy doesn't allow SSH from devices to PI. Therefore command: Copy flash://XXX.bin scp:// can't be successfully applied.
