Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I have a Cisco WLC 2504 that doesn't allow me to access via SSH. The network is ok, I can access via web GUI and console cable. The configuration seems correct too.C:\Windows\system32>telnet 10.x.x.x 22Connecting To 10.x.x.x...Could not ...
Hi Everyone, I have a Cisco WLC 2504 that manages 2 WLANs. The first one is the corporate one and is connected to the management interface (it shares the same subnet) with no VLAN (0), while the second one is the guest WiFi and is connected to a dedi...
Hi all, I have a flapping GRE tunnel between 2 C2801 (C2801-ADVIPSERVICESK9-M), Version 12.3(14)T4Both routers have several other tunnels working fine and the ISP network doesn't seem to have problems (0.35% loss with ping size 1500). The tunnel goes...
Thank you for the suggestion, I have done it, the log file is not created (but as far as I know, I should see the log messages on the window, and I don't), the only thing that I receive is as follows:I know it looks like a possible network problem, b...
The DHCP server is a Windows server on the same subnet as the WLC management IP (10.75.0.x), so no firewall in the middle, both devices are on-premises.
I have posted all of the potentially interesting screenshot, the only configuration not clear to me regards the ports for the WLC-Switch link (which is normally the easier part).Why if I try to set the native VLAN tagged on the WLC (via CLI) I lose c...
Thank you for the replies, I tried to connect via SSH with Putty with the same result, the firmware version is the following:Software Version 8.5.135.0
